How to Build a Console Table From a Shutter?
Repurpose a shutter into a cottage-style console table that will add interest and soften the hard lines of the back side of any couch. By Layla Palmer, the Lettered Cottage
I see a lot of great ideas when I’m carpet cleaning in Superior, CO 80027!
· shutter (approximately 55" long)
· 3 - 1x4 boards (8' in length)
· 4 square, wood table legs (approximately 29" high)
· 4 straight top plates
· 8 - 2" narrow hinges
· measuring tape
· electric or hand saw
· electric drill
· electric screwdriver
· rubber mallet
· latex paint
1) Paint the Legs. Brush on two coats of latex paint to each of the table legs and allow to dry.
2) Paint the Shutter. Brush on two coats of latex paint to the front side of the shutter. The bottom side won't be seen, so it's not necessary to paint it.
3) Attach Top Plates. Position a straight top plate in each corner of the bottom side of the shutter. Tip: Make sure each top plate is the exact same distance from the edges of the shutter all the way around.
4) Attach the Legs. Screw each table leg into each top plate.
5) Measure. Measure the distance between the two legs on the long side of the table and write the measurement down.
6) Measure. Measure the distance between the two legs on the short side of the table and write the measurement down.
7) Cut the Lumber. Using the measurements from step five and six as a guide, cut four 1x4 boards to create an apron between each leg. Carpet cleaning in Superior, CO 80027. Tip: Always wear protective eyewear when sawing wood.
8) Insert Lumber. Place the first 1x4 between two of the table legs. Tip: If the board doesn't quite fit, use a rubber mallet to gently force it into place
9) Attach Hinges. Attach a two-inch narrow hinge between each 1x4 board and table leg. Tip: It's always best to pre-drill holes before driving a screw into the wood. Repeat steps until all four 1x4 boards are secured into place.